Effect of the elastomer viscosity on the morphology and impact behavior of injection molded foams based on blends of polypropylene and polyolefin elastomers was written by Munoz-Pascual, Santiago;Saiz-Arroyo, Cristina;Vananroye, Anja;Moldenaers, Paula;Rodriguez-Perez, Miguel Angel. And the article was included in Journal of Applied Polymer Science in 2021.Computed Properties of C73H108O12 This article mentions the following:
The impact resistance of injection-molded polypropylene (PP) parts is severely reduced when they are foamed. It is necessary to implement strategies, such as elastomer toughening, to increase the impact behavior of foamed parts. However, the knowledge on the effect of elastomer addition on the morphol., cellular structure, and impact of injection-molded cellular parts is very limited. In this work, foamed parts based on blends of PP and polyolefin elastomers have been produced and characterized. A high and a low viscosity octene-ethylene copolymer (EOC) and a high viscosity butene-ethylene copolymer (EBC) were employed. The blends have been thermally and rheol. characterized. Solids materials and foams (relative d. 0.76) were injection-molded. The solid phase and cellular structure morphologies were studied using SEM. The results showed that elastomer toughening has been successful to obtain an improvement of the impact behavior in solid and cellular polymers. In this case, EOC materials provide an appropriate interfacial adhesion and optimized cellular structure which results in high impact resistance. The optimum elastomer to improve the properties is the EOC with a higher viscosity which provides impact resistance with n values below 3 due to the toughening of polymer matrix, thick skin thickness, and low cell size. In the experiment, the researchers used many compounds, for example, 2,2-Bis(((3-(3,5-di-tert-butyl-4-hydroxyphenyl)propanoyl)oxy)methyl)propane-1,3-diyl bis(3-(3,5-di-tert-butyl-4-hydroxyphenyl)propanoate) (cas: 6683-19-8Computed Properties of C73H108O12).
2,2-Bis(((3-(3,5-di-tert-butyl-4-hydroxyphenyl)propanoyl)oxy)methyl)propane-1,3-diyl bis(3-(3,5-di-tert-butyl-4-hydroxyphenyl)propanoate) (cas: 6683-19-8) belongs to esters. Esters are also usually derived from carboxylic acids. It may also be obtained by reaction of acid anhydride or acid halides with alcohols or by the reaction of salts of carboxylic acids with alkyl halides. Many esters have the potential for conformational isomerism, but they tend to adopt an s-cis (or Z) conformation rather than the s-trans (or E) alternative, due to a combination of hyperconjugation and dipole minimization effects. The preference for the Z conformation is influenced by the nature of the substituents and solvent, if present. Lactones with small rings are restricted to the s-trans (i.e. E) conformation due to their cyclic structure.Computed Properties of C73H108O12
Referemce:
Ester – Wikipedia,
Ester – an overview | ScienceDirect Topics